Fahrer Latz XL Mudflap

£15.00

Long enough to actually do the job. The LATZ XL is designed to seriously reduce spray from the front wheel — not just look like it might. The extra length keeps water, grit and road mess where it belongs, even at higher speeds. And if you want a bit more protection at the back, it works just as well on the rear wheel too.

Made from tough truck tarpaulin and reinforced where it counts, this is a simple, durable solution for year-round riding. Designed in Berlin and produced in cooperation with workshops for people with disabilities — because how things are made matters too.

Specs
Color: Black
Material: Truck tarpaulin
Length from mounting point: 285 mm

Optimised and reinforced for higher speeds

in the package

```
Mud flap LATZ XL
```
```
3 x cable tie
```

Mounting:

Thread a cable tie from behind through the two holes on the left and right of the bib so that the pointed ends are at the top and the fastener is at the bottom. Now turn the splash guard over and place it in the middle of the lower end of the mudguard. Place the cable ties on the left and right around the fender struts and tighten. Cut off the protruding ends of the cable ties with side cutters.

Long enough to actually do the job. The LATZ XL is designed to seriously reduce spray from the front wheel — not just look like it might. The extra length keeps water, grit and road mess where it belongs, even at higher speeds. And if you want a bit more protection at the back, it works just as well on the rear wheel too.

Made from tough truck tarpaulin and reinforced where it counts, this is a simple, durable solution for year-round riding. Designed in Berlin and produced in cooperation with workshops for people with disabilities — because how things are made matters too.

Specs
Color: Black
Material: Truck tarpaulin
Length from mounting point: 285 mm

Optimised and reinforced for higher speeds

in the package

```
Mud flap LATZ XL
```
```
3 x cable tie
```

Mounting:

Thread a cable tie from behind through the two holes on the left and right of the bib so that the pointed ends are at the top and the fastener is at the bottom. Now turn the splash guard over and place it in the middle of the lower end of the mudguard. Place the cable ties on the left and right around the fender struts and tighten. Cut off the protruding ends of the cable ties with side cutters.